For courtyards whose area is below 300 square meters, the most suitable option is Senix Outdoor Power Tools LXT 20V series, its lithium mower with 4.0Ah battery can be used continuously for 70 minutes, the cutting width is 38 cm, traveling speed is 5.2 km/h, single charge completion rate is 100%. Compared to gas power units, it saves lawn mowing time by 1.2 hours to 48 minutes and lowers energy consumption by 64% ($0.18 vs $0.5 per hour). For dense lawns with grass lengths over 10 cm, its intelligent load sensing system will automatically boost the torque to 28N·m, and its cutting efficiency is 23% greater than similar power tools. According to the 2024 Consumer Reports data, the loss of the series’ performance after 300 cycles is only 7%, and power delivery in standard gas models is reduced by 31%.
For yard size 300-800 SQM, Senix’s ProDrive 40V system is recommended, and with a twin battery configuration, there can be non-stop use for 180 minutes and an area coverage of 1,200 SQM. It comes equipped with a self-developed TurboBlade set of blades that maintain a speed of 5800RPM at a grass mass of 2.5kg/m³, which is 42% efficiency compared to the single-battery option. The measured data show that when cutting in slopes of 15°, the gravity compensation algorithm can maintain the cutting height deviation within ±1.5mm, while the traditional machinery tends to create 18% missing cutting area under this terrain. The system’s fast charging technology recovers 80% of power in 30 minutes, and through the smart power management module, saves 58% of wasted energy when multiple devices are used in coordinated operation. Having 600 square meters of yard using the ProDrive system reduced time cost per year from 36 hours to 22 hours and increased tool switching efficiency by 79%.
For the bigger properties that are over 800 square meters, Senix Commercial 80V platform provides professional-grade performance, with dual motor driving system for commercial mowers with the maximum torque output of 65N·m and management capacity equivalent to 5.5 HP gas equipment but at lower noise levels to 82 dB (gas versions are typically over 96 dB). It will work continuously for 240 minutes on a 10.0Ah battery and will cut about one section of 2,400 sq. m., reducing refueling stops by 92% compared to the fuel solution. At harsh conditions (grass length 20cm, humidity 85%), the efficiency of cutting is 89% of the nominal, as per GPE, but the output of the gas equipment falls by 37%. As per the equipment life cycle cost analysis, the ownership cost of the Commercial series is 58% lower than the fuel option over the five-year life, mainly due to the $127 per annum savings on oil, spark plug and air filter replacement.
Senix Outdoor Power Tools modular system guarantees accurate accommodation of special requirements. For multi-tree applications, the AXT series chainsaw removes 30cm diameter oak in 58 seconds, 29% faster than gas machines, and reduces vibration strength to 1.6m/s² (ISO 22868). During the cutting of hard shrubs, the blade frequency of the hedge scissors is up to 3200 times/minute, the cutting force is 35% larger than the normal model, and the ununiform part of the branches and leaves is in the error range of 0.2mm. In a dense leaf litter condition of 5kg/m², the JetWind leaf blower’s wind speed is constant at 73m/s±3%, the collection efficiency is 41% higher than that of the gas model, and the cost of operation is only 19% of the latter.
Senix Outdoor Power Tools’ competitive edge is based on smart eco-cooperation. Its 20V/40V/80V battery system is compatible with cross-mixing equipment, and intelligent voltage regulation technology increases the rate of energy use to 94%. With three-tool solution (lawn mower + leaf blower + chain saw) being utilized to maintain 1,000 square meters of lawn, Senix system reduced overall working time from 6.3 hours to 3.8 hours and increased tool switching effectiveness by 91%. With California AB1346 from 2024 (preventing the sale of small fuel garden equipment), Senix’s solution for electrification has resolved 98% of the regulatory features, and its environmental compatibility has maintained 97% performance output stability in the -20 ° C to 50 ° C test, providing a future-proof solution for gardens of any size.